Voxoa C50 Manual de usuario descargar pdf (Pagina 45)

E N G L I S H

6. MIC jack

This jack is used to connect a microphone to the mixer. Connect your microphone via 1/4 inch jack. The volume

output level for microphone will be controlled by its own respective VOLUME KNOB.

7. MIC Level control

The rotary knobs control the output volume of MICROPHONE.

8. MIC On/Off switch

To set MIC on and off.

9. Touch Sensor Level control

Adjust level of touch sensitivity for the Jog Wheel.

10. X-Fader Curve switch

Allow Allows adjusting the slope of corssfader. Rotate clockwise to shorten fade time with sharper cut off at

either end Rotate anti-clockwise to lengthen fade to gradually mix across fader and 50/50 mix in center only.

11. Monitor Mixing Mode selector

This function allows you to monitor the Cue level as well as the Master (main output) level in your headphones.

Channels Cue Level may only be monitored if the channel CUE function is selected. To select a channel cue

function press the CUE BUTTON that is directly associated with the speciﬁc channel you wish to monitor. You

may use the mixing function to blend both the Cue level and the MASTER level together.

12. Cue Level control

This rotary knob is used to adjust the headphone volume output level. Turn the knob in a clockwise direction to

increase the headphone volume.

13. Phones jacks

These jacks are used to connect your headphones to the device allowing you to monitor the cue channel.

Always be sure the CUE LEVEL VOLUME is set to minimum before you put the headphones on.

PART NAMES AND FUNCTIONS

FRONT PANEL

6 7 8 9 9 10 11 12 13

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 57 58

Sin comentarios

Voxoa C50 Manual de usuario Pagina 45